Explicit stress–strain equations for modeling frictional materials

In this paper, a comprehensive study on simulating the shearing behavior of frictional materials is performed. A set of two explicit equations, describing the relationship among the shear stress ratio and the distortional strain and the volumetric strain, are formulated independently. The equations contain three stress parameters and three strain parameters and another parameter representing the nonuniformity of stress and strain during softening. All the parameters have clear physical significance and can be determined experimentally. It is demonstrated that the proposed equations have the capacity of simulating the complicated shearing behavior of many types of frictional materials including geomaterials. The proposed equations are used to simulate the stress–strain behavior for 27 frictional materials with 98 tests. These materials include soft and stiff clays in both reconstituted and structured states, silicon sands and calcareous sands, silts, compacted fill materials, volcanic soils, decomposed granite soils, cemented soils (both artificially and naturally cemented), partially saturated soils, ballast, rocks, reinforced soils, tire chips, sugar, wheat, and rapeseed. It has been demonstrated that the proposed explicit constitutive equations have the capacity to capture accurately the shearing behavior of frictional materials both qualitatively and quantitatively. A study on model parameters has been performed.     

敦煌-格尔木铁路沿线风动力环境特征

敦煌-格尔木铁路沿线地形复杂、起沙因素多变、沙源丰富，沙害问题日益严重。目前对其风沙活动规律还未有研究，不利于防沙工作的开展。为此，通过对自北向南的5个观测点（S1、S2、S3、S4、S5）风速和风向的观测、计算和分析，利用平均风速、起沙风况及输沙势对敦格铁路沿线的风动力环境特征进行研究。结果表明：S5、S4和S3的风况对铁路风沙灾害防治意义较大。S5年平均风速、起沙风频率和输沙势最大，春季风沙活动最为强烈，且风向单一、风力强劲，风沙运动方向基本与铁路垂直，沙粒易在铁路附近堆积。S4夏季风沙活动最为强烈；S3春季风沙活动最为强烈，且风向单一，S4和S3的风沙运动方向与铁路夹角小于90°，附近沙源广阔，铁路易受风沙侵蚀，阻碍交通运营。     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Strain localization in sand: an overview of the experimental results obtained in Grenoble using stereophotogrammetry

Experimental results are presented from the extensive program of drained plane strain compression tests on sand carried out in Grenoble over the last two decades. Systematic analysis of photographs of the deforming specimen allowed for measuring deformations and determining strain fields throughout the test, that is: prior to, at, and after the onset of strain localization. The principles, details and accuracy of the procedure are described, as well as its suitability to properly depict the patterns of deformation. Findings concerning the occurrence and progression of strain localization are discussed. The issues of shear band orientation and thickness are addressed, as well as temporary and persistent complex localization patterns, and the volumetric behaviour inside a band after its formation. The influence of such variables as initial state of the sand (effective stress and relative density), specimen size and slenderness, as well as grain size, is discussed. Copyright © 2004 John Wiley & Sons, Ltd     

The characteristics of Asian dust events in Northeast Asia during the springtime from 1993 to 2004

The characteristics of Asian dust events that occurred in Northeast Asia during the springtime from 1993 to 2004 are investigated using 3-hourly SYNOP reports (World Meteorological Organization). Occurrences of blowing sand and dust storm are low in 1997 and 1999, but have increased rapidly since 2000. The maximum occurrence was recorded in 2002. Wind velocity of 6.5 m s^− 1 as a threshold wind velocity is not so exactly consistent with the occurrence of blowing sand. However, wind velocity of 14 m s^− 1 as a strong wind causing dust storm had similar tendency to those of dust storm and Dust Storm Index.Source regions of Asian dust are divided into three regions (A: dry arid, B: semi-arid, and C: cultivated), based upon the occurrence of blowing sand and dust storm. Eight meteorological stations are selected in three regions, which have frequent occurrences of blowing sand. Source regions of Asian dust that affect the Korean peninsula are gradually extending eastward. Positive anomalies of NDVI occurred in 1994, 1995, and 1998 when temperature was high and precipitation was heavy. However, the frequent occurrence of the dust phenomena is not always consistent with lots of vegetation, high temperature, and much precipitation in this study.     

Wolf-Rayet stars

Summary Recent literature on Population I Wolf-Rayet star research extending from the Milky Way to blue compact dwarf galaxies is reviewed, broken down into inventory, basic parameters and galactic distribution, atmospheres, binaries, intrinsic variability, mass loss, enrichment and evolution. Also the incidence of Wolf-Rayet stars with variable non-thermal radio emission, excess X-ray fluxes, and episodic/periodic IR excesses is reviewed. These phenomena appear to be associated with wind-wind interaction in wide long-period WR+OB binaries and with wind-compact object interaction in WR+c binaries, with orbit sizes of the order of magnitude of the WR radio photosphere sizes or larger.     

ELECTROCHEMICAL CORROSION BEHAVIOR OF STEEL IN THE JUNCTURE AREA OF SEA CLAY AND SAND

Corrosion behavior of steel in the juncture area of sea clay and sand was studied. The results show that galvanic corrosion occurred between steel samples buried in sea clay and sand, and that the polarity of the galvanic cell reversed after some testing later. The cause of reversing of polarity is discussed.     

Detecting the first objects in the mid-infrared with the Next Generation Space Telescope

We calculate the expected mid-infrared (MIR) molecular hydrogen line emission from the first objects in the Universe. As a result of their low masses, the stellar feedback from massive stars is able to blow away their gas content and collect it into a cooling shell where H₂ rapidly forms and IR roto-vibrational (as for example the rest-frame 2.12 μm) lines carry away a large fraction (up to 10 per cent) of the explosion energy. The fluxes from these sources are in the range 10⁻²¹–10⁻¹⁷ erg s⁻¹ cm⁻² . The highest number counts are expected in the 20-μm band, where about 10⁵ sources deg⁻² are predicted at the limiting flux of 3×10⁻¹⁸ erg s⁻¹ cm⁻². Among the planned observational facilities, we find that the best detection perspectives are offered by the Next Generation Space Telescope ( NGST ), which should be able to reveal about 200 first objects in one hour observation time at its limiting flux in the above band. Therefore, mid-IR instruments appear to represent perfect tools to trace star formation and stellar feedback in the high ( z ≳5) redshift Universe.